Configuring Video Tampering Alarm - HIKVISION DS-2DP0818ZIX User Manual

 Trigger Recording
Record a video when an event occurs.
Note:
You have to set the recording schedule to realize this function. Refer to Section 5.1 Storage
Settings for settings the recording schedule.
 Trigger Alarm Output
Trigger one or more external alarm outputs when an event occurs.
Note:
To trigger an alarm output when an event occurs, refer to Section 6.1.4 Configuring Alarm Output
to set the alarm output parameters.

6.1.2 Configuring Video Tampering Alarm

Purpose:
You can configure the camera to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the video tampering settings interface:
Configuration > Event > Basic Event > Video Tampering
2. Check the Enable checkbox to enable the tampering detection.
3. Set the tampering area. Refer to Step 4 in Section 6.1.1 Configuring Motion Detection.
4. Click
configuration is the same as the setting of the arming schedule for motion detection. Refer to Step
5 in Section 6.1.1 Configuring Motion Detection.
User Manual of PanoVu Series Network Camera
Tampering Alarm
Figure 6-7
tab to enter the arming schedule setting interface. The arming schedule
74