Configuring Intrusion Detection - HIKVISION DS-2DP0818ZIX User Manual

6.2.2 Configuring Intrusion Detection

Intrusion detection can set an area in the surveillance scene and once the area is entered, a set of alarm
action is triggered.
Steps:
1. Enter the intrusion detection interface:
Configuration > Events > Smart Event >Intrusion Detection
2. Check the Enable checkbox.
3. The event triggered and park action related PTZ movement will be locked for 180 seconds after you
enter the intrusion detection interface. Optionally, you can click the
manually activate the movement, or lock the movement when the button turns to
by clicking it.
4. Draw area.
(1) Select the Region No.in dropdown list.
(2) Click
(3) Click on the image to specify a corner of the rectangle, and right-click the mouse after four
corners are configured.
5. Configure the parameters for each defense region separately.
 Region: In this column, you can select a region.
 Threshold: Range [0-10s], the threshold for the time of the object loitering in the region. If you
set the value as 0, alarm is triggered immediately after the object entering the region.
 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object which can
trigger the alarm, when the sensitivity is high, a very small object can trigger the alarm.
6. Click
configuration is the same as the settings of the arming schedule for motion detection. Refer to Step 5
in Section 6.1.1 Configuring Motion Detection.
User Manual of PanoVu Series Network Camera
Configuring Intrusion Area
Figure 6-13
to draw a rectangle on the image as a defense region.
tab to enter the arming schedule setting interface. The time schedule
79
button to