Rapid Focus - HIKVISION DS-2DP0818ZIX User Manual

4. Set the tracking duration. The camera stops tracking when the duration time is up. The duration
ranges from 0 to 60 seconds.
5. Click
6. You can select Add, Delete, and Clear All to edit the calibration sites. The coordinates and PTZ
positions of selected calibration sites will appear in the list below. In auto calibration mode, click
Calibration to refresh the PTZ position; and in manual calibration mode, click
PTZ position.
Notes:
 In auto calibration mode, the more similar is the PTZ view and the panoramic view, the panorama
tracking gets more accurate.
 The more distant manual calibration sites are to each other, the panorama tracking gets more
accurate.

4.2.10 Rapid Focus

Purpose:
After this function is enabled, perform calibration and the focus can be quicker than quick focus.
Steps:
1. Enter the Position Settings interface:
Configuration > PTZ > Position Settings.
2. Check the Enable checkbox to enable the Rapid Focus.
3. Drag the red line on the live view image to the calibration position according to the user. You can
drag the ends of the red line to adjust the length of the line.
4. Click Start Calibration. There is the notice Calibrating on the live view image and the camera lens
performs auto focus.
5. After calibration, there is the notice Calibration succeeded on the live view image.
6. Click Save to save the settings.
7. You can repeat step 3 to step 6 to configure rapid focus for multiple scenes. Up to four scenes are
supported.
User Manual of PanoVu Series Network Camera
to set the current zoom ratio as the tracking zoom ratio.
Figure 4-21
Calibration Parameters
58
to refresh the