Configuring Alarm Input - HIKVISION DS-2DP0818ZIX User Manual

5. Click
Notify Surveillance Center, and Trigger Alarm Output are selectable. Refer to Step 6 in Section 6.1.1
Configuring Motion Detection.
6. Click

6.1.3 Configuring Alarm Input

Steps:
1. Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2. Choose the Alarm Input No. and the Alarm Type. The alarm type can be NO (Normally Open) and
NC (Normally Closed).
3. Edit the name in
(optional).
4. Click
configuration is the same as the setting of the arming schedule for motion detection. Refer to Step
5 in Section 6.1.1 Configuring Motion Detection.
5. Click
Notify Surveillance Center, Upload to FTP/Memory Card/NAS, Trigger Alarm Output and Trigger
Recording are selectable. Refer to Step 6 in Section 6.1.1 Configuring Motion Detection.
6. You can also choose the PTZ linking for the alarm input. Check the relative checkbox and select the
No. to enable Preset Calling, Patrol Calling or Pattern Calling.
7. You can copy your settings to other alarm inputs.
8. Click
User Manual of PanoVu Series Network Camera
tab to select the linkage method taken for the video loss alarm. Send Email,
to save the settings.
Alarm Input Settings
Figure 6-8
tab to enter the arming schedule setting interface. The arming schedule
tab to select the linkage method taken for the video loss alarm. Send Email,
to save the settings.
to set a name for the alarm input
75