Configuring Region Exiting Detection - HIKVISION DS-2DP0818ZIX User Manual

3. Select the region from the dropdown list for detection settings.
4. Click the
5. Click on the live video to specify the four vertexes of the detection region, and right click to
complete drawing.
Repeat the step to configure other regions. You can click the
regions.
6. Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the object which can
trigger the alarm, when the sensitivity is high, a very small object can trigger the alarm.
7. Detection Target: Set the detection target for the region entrance detection. You can select human,
vehicle, or all (human &vehicle) as the detection target from the dropdown list. If Human is selected,
only human beings will be identified as detection objects and as well as Vehicle.
8. Click
configuration is the same as the settings of the arming schedule for motion detection. Refer to Step
5 in Section 6.1.1 Configuring Motion Detection.
9. Click
surveillance center, send email, upload to FTP, trigger channel, smart tracking and trigger alarm
output are selectable. Refer to Step 3 in Section 6.1.1 Configuring Motion Detection.
10. Click

6.2.5 Configuring Region Exiting Detection

Purpose:
User Manual of PanoVu Series Network Camera
Configuring Region Entrance Detection
Figure 6-15
button to start the region drawing.
tab to enter the arming schedule setting interface. The time schedule
tab to select the linkage method taken for the video loss alarm, Notify
to save the settings.
82
button to clear all pre-defined