R&S SGU100A Getting Started page 18

®
R&S SGU100A
In standby state, the button is orange. The standby power mode keeps the
power switch circuits and the remote control system active.
Start-up and booting
The instrument boots the operating system and starts the instrument firmware.
During the booting process, the green [POWER ON /STAND BY] key blinks. If the
previous session was terminated regularly, the instrument uses the last setup with
the relevant instrument settings.
Once the startup procedure has been terminated, the instrument is ready for
operation.
In the R&S SGMA-GUI, select "Instrument > Preset" function to return the
instrument to its defined reset/preset state, if the current setup is no longer
relevant.
To customize the start settings, use the "SGMA-GUI > File > Save As/Open" func-
tion.
To shut down the instrument
To shut down the R&S SGU, proceed as described below.
Risk of losing data
If you switch off the running instrument using the rear panel switch or by
disconnecting the power cord, the instrument loses its current settings.
Always press the [POWER ON/STANDBY] key first to shut down the appli-
cation properly.
1. Press the [POWER ON /STAND BY] key to save the current setup, shut down
the operating system and set the instrument to standby state.
The [POWER ON /STAND BY] LED must be orange.
Tip: If the instrument is operated manually via the R&S SGMA-GUI, select
"SGMA-GUI > Instrument Name > Setup > Standby".
Getting Started 1418.2070.02 ─ 08
Preparing for Use
Putting into Operation
16