R&S SGU100A Getting Started page 42

®
R&S SGU100A
Figure 4-2: Example of a setup of the R&S SGU as an upconverter
1. Connect the test equipment as shown in
may be needed to fulfill the requirements of the connected local oscillator. To
find out what connections are needed refer to its user manual.
2. Switch on the R&S SGU.
The [POWER ON/STANDBY] key has to be green and not blinking.
3. Press the [ID] key on the front panel the R&S SGU (only required if the com-
ponents are connected via a company network).
4. On the connected remote PC, start the R&S SGMA-GUI software application.
The main panel of the application and the configure instruments dialog open.
The R&S SGU is added automatically to the instruments list and to the main
panel of the R&S SGMA-GUI software.
The main panel provides a quick access to the main settings of the configured
and activated instruments. The display shows one row per instrument with the
instrument specific settings. The rows comprise the instrument, the connec-
tion state, the used frequency and power level and the state of the RF output
and the modulator.
Getting Started 1418.2070.02 ─ 08
First Steps with the Instrument
R&S SGU as a Standalone Upconverter
Figure 4-2. Additional connections
40