R&S SGU100A Getting Started page 37

®
R&S SGU100A
For higher setting/ measuring speeds, use a PCIe switch and PCIe connec-
tions.
1. Connect the test equipment as shown on
a) Connect the R&S SGS, R&S SGU and the controller to a LAN switch.
b) Connect the [RF OUT] of the R&S SGS to the [LO IN] of the R&S SGU.
c) Connect the [TRIG] connectors of the R&S SGS and the R&S SGU.
d) Connect the [RF OUT] of the R&S SGU to the [RF IN] of the signal ana-
lyzer.
2. Switch on the R&S SGS and the R&S SGU.
The [POWER ON/STANDBY] keys have to be green and not blinking.
3. Press the [ID] keys on the front panels of the R&S SGS and the R&S SGU
(only required if the components are connected via a company network).
4. On the connected remote PC, start the R&S SGMA-GUI software application.
The main panel of the application and the configure instruments dialog open.
Both instruments are added automatically to the instruments list and to the
main panel of the R&S SGMA-GUI software.
The main panel provides a quick access to the main settings of the configured
and activated instruments. The display shows one row per instrument with the
instrument specific settings. The rows comprise the instrument, the connec-
tion state, the used frequency and power level and the state of the RF output
and the modulator.
Getting Started 1418.2070.02 ─ 08
First Steps with the Instrument
R&S SGU as an Extension to the R&S SGS
Figure 4-1:
35