R&S SGU100A Getting Started page 44

®
R&S SGU100A
9. Change the settings of the LO to the required values.
10. Select "SGMA-GUI > Instrument Name > Ext. Local Oscillator > Confirm
External LO Settings" to apply the changes.
The 15 GHz signal is output at the [LO OUT] connector at the rear panel of
the R&S SGU.
Identifying a specific instrument
If several instruments are active in the R&S SGMA-GUI, use one of the
device identification functions to identify a specific device:
● Select "SGMA-GUI > Instrument Name > Setup > Remote > Remote
Channels > Device Identify". The green [LAN] LED on the front panel of
the instrument blinks.
● Press the [ID] key on the instrument's front panel. The "Edit Instrument"
dialog of the respective instrument opens.
Getting Started 1418.2070.02 ─ 08
First Steps with the Instrument
R&S SGU as a Standalone Upconverter
42