R&S SGU100A Getting Started page 28

®
R&S SGU100A
Setting up a USB connection from a PC to the R&S SGU
If your network does not support DHCP, you can set a USB connection between a
PC and a R&S SGU.
Prerequisite: the computer and the R&S SGU are turned on and running.
1. Start the R&S SGMA-GUI.
2. Connect the computer and the R&S SGU with a USB cable.
The new instrument should appear automatically.
If the instrument does not appear automatically, you can open the "Setup >
Instruments > Configure Instruments" dialog and click "Scan".
3. If your network does not support DHCP, you can now set a static IP address to
your computer.
a) Assign a static IP address to the instrument, see
address to the R&S SGU"
b) Assign a static IP address to the PC, see
your Windows-PC network card"
c) Edit the instrument settings in the "Edit Instrument" dialog ("SGMA-GUI >
Setup > Instruments > Instrument> Edit").
Connecting a USB device
If you connect a USB device (memory stick, CD-ROM, an instrument) to the
R&S SGU, the R&S SGU acts as a host.
To connect a USB device to the interface of the R&S SGU, always connect the
USB type Micro-A connector to the R&S SGU. Refer to the documentation of the
USB device to find out which USB connector type you can connect to the USB
device.
The Figure 2-2 illustrates schematically the required connector type to emphasize
on the different connector shape.
Figure 2-2: USB type Micro-A connectors
If you connect an R&S SGS to an R&S SGU via a USB cable, perform the steps
as described in chapter "Setups for Connecting an R&S SGS and an R&S SGU"
of the user manual.
Getting Started 1418.2070.02 ─ 08
Connecting an External PC and Devices
on page 23.
"Assigning a static IP address to
on page 23.
Preparing for Use
"Assigning a static IP
26