R&S Sgu As A Standalone Upconverter - R&S SGU100A Getting Started

®
R&S SGU100A
Identifying a specific instrument
If several instruments are active in the R&S SGMA-GUI use one of the
device identification functions to identify a specific device:
● Select "SGMA-GUI > Instrument Name > Setup > Remote > Remote
Channels > Device Identify". The green [LAN] LED on the front panel of
the instrument blinks.
● Press the [ID] key on the instrument's front panel. The "Edit Instrument"
dialog of the respective instrument opens.
4.2 R&S SGU as a Standalone Upconverter
This section provides an example on how to configure the instrument to convert a
continuous wave (CW) signal. The signal in this example is provided by an incom-
patible signal generator (local oscillator).
In the following example, the instrument is manually operated via the R&S
SGMA-GUI software. The R&S SGU in this example is a base unit equipped with
the frequency option R&S SGU-B120.
Configuring the R&S SGU to convert a CW signal
As a prerequisite for this example, the R&S SGMA-GUI software has to be instal-
led on a remote PC and the local oscillator has to be prepared for use.
Getting Started 1418.2070.02 ─ 08
First Steps with the Instrument
R&S SGU as a Standalone Upconverter
39