Software:
•
Enable/disable of Ethernet and SCSI ports by software.
•
Enable/disable of video by hardware.
•
Serial/parallel port mapping/disable by software
•
Remote operation/monitoring (VT-100 serial port console redirection),
•
Programmable two-stage watchdog timer by software
•
Fully compatible with existing application software using platforms PC and MS-
DOS
, Windows
Warp, QNX
•
Supports: Advanced Configuration and Power Interface (ACPI 1.0), Advanced
Power Management (APM 1.2), advanced thermal management (resume, overheat
alarm and auto slow down) and Green support.
•
Hardware monitor (voltages, temperature, and fan speed),
•
Power failure circuit
•
Two year warranty.
The cPCI-MXS64 can be purchased either for front plate I/O interfacing (video serial port,
Ethernet) or RTM (Rear Transition Module) I/O interfacing (no interconnection capability
available on the front plate) through cPCI I/O connectors and backplane.
CompactPCI Connectors
Rear panel cPCI connectors are PICMG 2.0 Rev2.1 CompactPCI
CompactPCI connectors are located at the rear edge of the board. The complete cPCI
connector configuration is composed of five connectors referred to as J1, J2, J3, J4, and J5.
Their function is described below:
J1/J2
carry out arbitration and PCI bus signals, and power.
J3/J4/J5
handle I/O signals.
CompactPCI
connector is also known as 2mm Hard Metric connector.
3.1, Windows
, NOVELL
, and UnixWare
95, Windows
NT, Windows
.
1-3
Product Description
®
2000, OS/2
specification compliant.