Table of Contents
Advertisement
NOTE
For more information on the ECP protocol, please refer to the
Extended Capabilities Port Protocol and ISA Interface Standard (available
from Microsoft Corporation) or contact our Technical Support department.
2.7. POWER MANAGEMENT
Power Management features are supported at the BIOS level. All Power Management
options are described in Section 4.1.8 – Power Management Setup.
2.8. SCSI INTERFACE
The boards feature SYM53C895 PCI to Ultra2 SCSI I/O Processor. Supports Ultra2
SCSI synchronous transfer rates up to 80 Mbytes/s on a 16-bit, LVD SCSI bus..
Signals are available through J3-J4 cPCI I/O connector.
Signal Path
SCSI interface signals are only available through the J3-J4 cPCI I/O connector or
through RTM (Rear Transition Module).
Related Jumpers
W6 – To determine the SCSI termination (hardware, software or disabled)
BIOS Settings
11.3.7 Integrated Peripherals: Enable/Disable the Onboard PCI SCSI Chip.
To operate with SCSI devices the onboard SCSI controller must enabled through the
AWARD BIOS setup program
.
2-7
Onboard Features
Advertisement
Table of Contents
