Cpu/Board Features Setup - Kontron cPCI-MXS64 Technical Reference Manual

cPCI-MXS64 Technical Reference Manual

4.1.10 CPU/Board Features Setup

BIOS
Option
Defaults
Current Processor(s) nnn
Speed
Front Side Bus Speed nnn
. Thermal
Management
. Thermal Audio Alarm
. CPU 1 Die
Temperature
. Resume Alarm (°C)
. Overheat Alarm (°C)
. CPU1 Local
Temperature
. Resume Alarm (°C)
. Overheat Alarm (°C)
Save CMOS in Flash
Watchdog Timer
Watchdog After POST
Watchdog Duration 262144
(ms)
Current CPU Fan 1
and 2 speed
Current Vcpp1 and 2
Vin values : +12V,
+5V, +3.3V, +2.5V
Setup Possible
Defaults Settings
nnn nnn
nnn nnn
Thermal Management Options:
Dis. Dis. En./Dis.
Dis. Dis. En./Dis.
- - Varies
50 50 10-70
70 70 30-90
- - Varies
42 42 10-70
50 50 30-90
Dis. Dis. En./Dis.
Dis Dis En./Dis.
Ds Dis En./Dis.
262144 64 to
262144
- - Varies
- - Varies
- - Varies
This option displays the current processor speed.
This option displays the current Front Side Bus speed. This speed
is selected by the CPU auto-detection logic.
When this option is enabled, the CPU temperature is monitored.
Whenever the CPU overheats, the CPU slows down to lower the
temperature.
When the Thermal Management option and this option are
enabled, a continuous audible alarm is sounded when the
temperature specified in the Overheat Alarm options is reached.
Such an alarm may not be supported by the Operating System.
Displays the current die (internal) CPU temperature, when
Thermal Management is enabled.
The CPU will be slowed down (Doze mode) when it reaches the
selected Overheat Alarm (°C) temperature.
Full speed (Normal mode) will be resumed when the temperature
comes down to the selected Resume Alarm (°C) temperature.
A minimum of + 4° is automatically ensured for the Overheat
Alarm temperature with reference to the Resume Alarm.
The CPU will be slowed down (Doze mode) when it reaches the
selected Overheat Alarm (°C) temperature.
Full speed (Normal mode) will be resumed when the temperature
comes down to the selected Resume Alarm (°C) temperature.
A minimum of + 4° is automatically ensured for the Overheat
Alarm temperature with reference to the Resume Alarm
Displays the current case (external) CPU temperature, when
Thermal Management is enabled.
The CPU will be slowed down (Doze mode) when it reaches the
selected Overheat Alarm (°C) temperature.
Full speed (Normal mode) will be resumed when the temperature
comes down to the selected Resume Alarm (°C) temperature.
A minimum of + 4° is automatically ensured for the Overheat
Alarm temperature with reference to the Resume Alarm.
Saving CMOS memory content into Flash Memory will prevent to
loose CMOS options when battery fails.
This option enables the Watchdog option when the POST is
running.
This option enables Watchdog circuit after the POST sequence
Use this option to setup duration time (in ms) of the Watchdog
timing circuitry.
Speed sensing device sets this value according to the fan speed.
If no fan is installed or if a fan has no tachymetric capability, this
value will be 0.
This value is set according to the actual value of Vcpp1 & Vcpp2
The values of these voltages are each displayed according to the
current value.
4-13
Description