AMX AutoPatch Epica-128 User Manual page 76

Advanced Configuration: Modifying Virtual Matrices
The information in the dialog boxes for the instructions below is based on the
following scenario. A 64x64 composite router is reconfigured as 32x32 Y/c
router by creating a new virtual matrix, VM2, that switches 32 channels of "Y"
and 32 channels of "c" using the previous "composite" channels.
Note: For additional information on creating virtual matrices, see the X
Help file. To access the Help file topic for an open dialog box, press F1.
To create a new virtual matrix:
1. From the Virtual Matrix menu, select Add Virtual Matrix.
The Assign Virtual Matrix Signals dialog box opens.
Select
the signal
Click
Assign Signal
2. Under the Supported System Signals list (use either tab), select the signals
for the new VM (to select multiple signals, hold down the Control key) and
click Assign Signal.
3. Under Virtual Matrix Info, enter a number and a unique name. Click OK.
The Assign Signals to Matrices dialog box opens.
Select signal
Select enclosure
Select the
physical matrix
Click
Assign Matrix
4. From the Available Signals box, select the signal.
5. If applicable – For a multi-enclosure system, from the Enclosure drop down
list, select the correct enclosure.
B-6 Epica-128 & Epica-256 Installation & Setup
N
Connect
Enter a number and name
Check the signals
to be assigned
Click OK
Check the settings
Click OK