Chapter 3 - Disconnecting Switches - AMX AutoPatch Epica-128 User Manual

Disconnecting Switches
The characters and numbers in a Disconnect command tell the system which
input or output to disconnect on which level. Command characters and numbers
appear on the screen when the system accepts them. A command string has
successfully executed when the entered "T" command appears. If a character or
number is not accepted, a different character appears and all or part of the
command is not executed. For explanations of other possible responses,
see page 1-6.
In disconnect commands, enter multiple levels and outputs or inputs by including
a space between each set of numbers. Enter a range of outputs or inputs by
inserting a colon (:) between the lowest and highest numbers of the range.
If the level is not specified in the Disconnect command, the command is
executed on the default level, which is normally Level 0 (e.g., DO67T
disconnects Output 67 on Level 0).
Caution: Disconnecting an input disconnects all the outputs receiving that
source signal.
The following instructions provide command string formats for disconnecting
swtiches by designating either inputs (sources) or outputs (destinations).
To disconnect a switch, enter the Disconnect command below. Replace the
"#"s with the level and input or output number(s).
DL#O#T or DL#I#T
To cancel an incorrect or incomplete BCS command, enter "X".
Disconnect Examples:
BCS Command
DL0O214T Disconnects Output 214 on Level 0
DL2O3 5:9 11T Disconnects Outputs 3, 5, 6, 7, 8, 9, and 11 on Level 2
Disconnects all outputs connected to Input 109 on Level 2
DL2I109T
Disconnects all outputs connected to Inputs 72, 98, and 150 on Level 1
DL1I72 98 150T
BCS Serial Control Protocol
Action
3-1