Table of Contents
Advertisement
4. Perform a test switch to ensure the Epica is working properly (see Chapter 7,
4.2 Attaching External X
An X
Link (X
panels, such as the CP-20A or CP-10. AutoPatch X
include SBCs, Preset SBCs, SDUs (Status Display Units), etc.
The instructions below are for attaching a device to the Link (X
found on the CPU board. For more information, see the individual device's
documentation.
Communication Cable Requirements
q
q
To establish a Link port connection with an X
1. Attach one end of the X
2. On the CPU, unplug the Link connector.
3. Loosen the screws on the Link connector.
4. Insert the two wires of the X
50 ohm
termination connector
Figure 13: Insert wires into X
(if COM port settings do not match, enter the applicable values from the
Epica table). Click OK. A short splash screen appears.
"Executing a Test Switch").
N
Net device is any device that sends and receives X
N
Net) port. AutoPatch X
A two-conductor, 20 AWG, 7/28 strand cable with a drain wire or shield,
such as Alpha 2412C (customer supplied)
Maximum length of cable: 1,000 ft. (304.m) total, including linked panels
N
Net link cable to the corresponding port on the
device (see the individual product documentation).
connector leaving the center slot empty (see Figure 13).
Note that either wire can be inserted into either of the outer slots.
ENC 2
N
Net connector on CPU
Epica-128 & Epica-256 Installation & Setup
Attaching & Setting Up External Serial Controllers
N
Net Controllers
N
Net protocol over the
N
Net control devices include remote control
N
Net accessory devices
N
Net device:
N
Net link cable from the device into the Link
N
Net ) port,
4-5
Advertisement
Chapters
Table of Contents
Troubleshooting
