Assigning The Vi Sync Board To A Virtual Matrix - AMX AutoPatch Epica-128 User Manual

4. Check the splash screen to be sure the VI Sync board has been detected and
I/O slots: [[.....text will vary according to I/O boards in system.....]]
VI Sync board
Sync board detected: checking for sync signal...ok.
Interface 1: BCS mode RS232 port, 9600 (8/1/N/E/NS)
Interface 2: BCS mode RS232 port, 9600 (8/1/N/E/NS)
If the sync board is not detected and enabled:
(The splash screen either reports a failure or does not report on the sync board.)
q
q
q
q

Assigning the VI Sync Board to a Virtual Matrix

For system upgrades, the VI Sync board must be assigned to the virtual matrix
(VM) in X
ä
ä
Caution: Completing the steps below will invalidate any global presets stored
on the system and will result in loss of any custom names (labels).
The VI Sync board needs to be enabled for both the hardware and the virtual
matrix in X
To assign a VI Sync board to a VM using X
1. Using X
is enabled.
Power the system down.
Ensure the board is aligned with the board guides and is firmly in place.
Check that the source of the master sync signal is providing a good signal.
Repeat Steps 3 and 4. If the sync board is still not detected, contact technical
support (see page 7-3).
N
Connect using one of the following two methods.
If the original configuration file has not been modified, use X
load the new file that shipped with the board (see "Loading a Configuration
File" on page 8-9). The new file automatically assigns the VI Sync board to
the VM.
If the original configuration file has been modified (local presets, names,
etc.) and you do not want to replace it, update the file and reload it using the
following steps.
N
Connect and then downloaded to the system.
N
Connect, open your configuration (.xcl) file. (X
on the AMX AutoPatch Software & Documentation CD.) If you do not have a
configuration file, refer to "Discovering a System" on page 8-4.
Epica-128 & Epica-256 Installation & Setup
Assigning the VI Sync Board to a Virtual Matrix
Sync switching enabled.
N
Connect:
N
Connect is located
N
Connect to
A-5