Appendix A - System Error Codes - AMX AutoPatch Epica-128 User Manual

System Error Codes
This appendix provides an overview of common error codes that can appear for
Epica systems when this feature is enabled. The table below lists the error code,
the name of the code, the meaning of the code, and some basic troubleshooting
strategies (additional troubleshooting strategies are included on page A-2). This
list is not intended to be comprehensive. If an error code appears that is not
listed, note the specific number and contact technical support (see page A-3).
The first letter of the error code indicates the following:
q E = Error
q W = Warning
q A = Alarm* (requires immediate attention)
q I = Information*
* Because these codes very rarely appear, they are not included in the table.
To enable error code reporting: Enter $ERR=1! (System responds with V).
To turn off error code reporting: Enter $ERR=0!
Note: If the power is cycled, you will need to enable error code reporting again.
BCS Serial Control Protocol A-1