Appendix B - Advanced Configuration: Modifying Virtual Matrices - AMX AutoPatch Epica-128 User Manual

Advanced Configuration:
Modifying Virtual Matrices
Applicability Notice: This appendix applies to X
Your AMX AutoPatch Distribution Matrix is pre-configured at the factory. It is
ready to switch once the source and destination devices are attached. The
configuration file does not need any advanced modification unless you change
the hardware or want to change or add virtual matrices. Any new equipment for
upgrading an existing system will be shipped from the factory along with a new
configuration file to be loaded onto the system. We strongly recommend using
the new file instead of attempting to modify the existing configuration file to
accommodate the new equipment.
Important: If making any modifications other than customizing channel
names, creating local presets, or changing remote control panel passwords,
provide technical support with a copy of the modified .xcl file for future
support.
If your configuration file needs any type of additional advanced modification, we
strongly recommend contacting technical support (see page 7-3) to request a
modified file or ask for assistance.
Caution: Virtual matrix modifications are an advanced feature of X
that should not be attempted unless you are extremely familiar with X
and the AMX AutoPatch Distribution Matrix being configured.
Three advanced virtual matrix related tasks are covered in this chapter:
ä Joining (combining) virtual matrices
ä Creating breakaway virtual matrices
ä Creating a new virtual matrix
Important: Save a backup copy of the existing configuration file if you find it
necessary to modify the file for any reason.
Epica-128 & Epica-256 Installation & Setup
N
Connect version 2.4.0.
N
Connect
N
Connect
B-1