Shrouding Kit - Schulte FX-1800 Operator's Manual

OPERATION
To raise the front of the cutter the lift rod needs to
be shortened. To lower the front of the cutter the lift
rod needs to be lengthened. To do this loosen the
nuts on the rear of the lift rod and adjust them until
the proper deck pitch is set. Once the deck pitch is
set, retighten the jam nut.
Lift Rod Adjustment

6.4 Shrouding Kit

The shrouding on the FX-1800 includes a fixed
component and an adjustable component.
For a wider material distribution, the shrouds should
be set to the position closest to the cutter. To
reduce the amount of material distributed, the
shrouds should be set to the position furthest from
the cutter.
FX-1800/FX-1200 07/20 Operation Section 4-14
© 2020 Alamo Group Inc.