Schulte FX-1800 Operator's Manual page 119

Clutch Slips Excessively
Uneven cut
Uncut Material
Poor Shredding
Windrowing or Uneven
Material Distribution
FX-1800/FX-1200 07/20
© 2020 Alamo Group Inc.
OPERATION
Clutch linings badly worn or
plates warped.
Too much power for clutch.
Oil on facings.
Friction facings glazed.
Excessive ground speed.
Blades worn, dull or bent.
Mower not level side to side.
Improper height adjustment.
Low tractor tire pressure on
one side.
Turning too fast.
Tractor tires push grass down.
Damaged Mower pan.
Excessive ground speed.
RPM too low.
Improper blade for direction of cut.
Excessive ground speed.
Cutting too high.
Material heavy and lush.
Excessive ground speed.
Conditions too wet.
Operation Section 4-61
Repair clutch per maintenance
section of manuals.
Reduce ground speed and material
intake.
Replace facings.
Clean with emery cloth.
Reduce ground speed.
Replace blades.
(Refer to Maintenance Section)
Adjust. (Refer to Assembly Section)
Adjust Mower height.
(Refer to Assembly Section)
Adjust tire pressure. (Refer to your
Tractor Operator's Manual)
Reduce ground speed when turning.
Adjust your tractor wheel spacing.
(Refer to Operation Section)
Repair or replace as necessary.
Reduce ground speed.
Use full PTO speed. (Refer to your
Tractor Operator's Manual)
Install blades so rotation is correct.
Raise the front of Mower relative to the
rear to hold and circulate material
longer. (Refer to the Operation
Section-Setting the Mower-Setting
Deck Height) Reduce ground speed.
Lower cutting height. (Refer to the
Operation Section-Setting the Mower-
Setting Deck Pitch)
Raise the front of Mower relative to the
rear. (Refer to the Operation Section
Setting the Mower-Setting Deck
Height)
Reduce ground speed.
Wait for conditions to dry. Reduce
ground speed.