Transporting The Tractor And Implement - Schulte FX-1800 Operator's Manual

13. TRANSPORTING THE TRACTOR AND IMPLEMENT

Inherent hazards of operating the tractor and implement and the possibility of accidents are not left behind
when you finish working in an area. Therefore, the operator must employ good judgement and safe operation
practices when transporting the tractor and implement between locations. By using good judgement and
following safe transport procedures, the possibility of accidents while moving between locations can be
substantially minimized. OPS-U- 0017
Never allow children or other persons to ride on the Tractor or Implement.
Falling off can result in serious injury or death.
Before transporting the tractor and mower, idle the
tractor engine, disengage the PTO and wait for all
mower moving parts to come to a complete stop.
Once all mower parts are completely stopped, raise
the mower to transport height.
raising the mower, maintain at least 1" clearance
between the driveline and mower deck. If additional
mower deck height is needed for safe transport,
disconnect the driveline from the tractor and secure
its end to the mower deck. The mower can then be
raised to the maximum lift height. OPS-R-0033
If the tractor's hydraulic pump is not independent of
the tractor PTO, or if the tractor PTO has to be run
to have hydraulic power, disconnect the mower
driveline from the tractor PTO output shaft. Secure
the driveline to the mower deck to prevent driveline
damage or loss during transport. OPS-R-0034
FX-1800/FX-1200 07/20
© 2020 Alamo Group Inc.
OPERATION
NOTE: When
Operation Section 4-47
(SG-10)