Schulte FX-1800 Operator's Manual page 53

ASSEMBLY
Plug the main harness to the input end of the light module. Using plastic wire ties, route the harness along the
hydraulic hoses to the front of the rotary cutter. Allow enough slack in the harness for turning.
Test the circuit. The lights should operate in unison with your tractor lights. If the turning lamps are opposite to
the tractor, reverse the output to extension harness connections. If the lights do not work at all, check all
connections are snug.
FX-1800/FX-1200 07/20 Assembly Section 3-7
© 2020 Alamo Group Inc.