Schulte FX-1800 Operator's Manual page 73

OPERATION
Figure Ops-1014 shows a FX-1800 cutter set-up with clockwise blade rotation on the center section and right
wing, and counter clockwise blade rotation on the left wing.
EXAMPLES:
If there is material buildup in Sections B + E, raise shrouds 1+ 5 to allow some material out sooner.
If more material is found in Sections A + B and less in C + D, then shroud 2 can be lowered to allow less
material from the enter section.
If a lot of material is found in sections A + F, then lower the rear end of shrouds 1 + 5 to bring more material
around towards the center.
FX-1800/FX-1200 07/20 Operation Section 4-15
© 2020 Alamo Group Inc.