Reassembly - Schulte FX-1800 Operator's Manual

Rotary cutter
Table of Contents

Advertisement

3. Separate the parts and inspect for signs of
corrosion, cracks and rust.
4. Clean the parts using brake cleaner and a wire
brush.
5. Inspect the thickness of the friction linings and
replace them if they are less than 2.5 mm in
thickness (new friction linings are 3.2 mm
thick).

Reassembly

1. Install the bushing (3) in the flange yoke (2). Ensure it seats fully.
2. Reassemble the clutch as shown in the diagram (Figure Mnt-R-0292). Be careful not to contaminate any
of the internal parts of the clutch with grease or oil from hands or tools during reassembly.
FX-1800/FX-1200 07/20
© 2020 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2 seriesFx-1200

Table of Contents