Assembly From Truck Shipment - Schulte FX-1800 Operator's Manual

ASSEMBLY

Assembly from Truck Shipment

The following are instructions to set up a FX-1800
cutter that has been delivered on a truck.
When the cutter is received the hitch will be flipped
back onto the cutter as shown on Figure AsmP-R-
0465. The hitch must be flipped down into working
position and pinned to the tension link. Care should
be taken when flipping the hitch down as it is heavy
and will want to fall when it over centers so a lifting
device should be used. Line up the tension link and
the hitch as shown in Figure AsmP-R-0125. Use
the 1" washer and cotter pin that are provided to
attach the tension link to the hitch as shown in
Figure AsmP-R-0126.
FX-1800/FX-1200 07/20 Assembly Section 3-9
© 2020 Alamo Group Inc.