Table of Contents
Advertisement
9. To avoid confusion among handpieces, PACE recommends
the use of colored cable markers (P/N 6993-0136 Cable
Marker Kit) to identify the particular handpiece . Attach
any two like colored markers, one to each end of the
handpiece power cable or air hose. Select and use a
different colored marker for each handpiece. Labels are also
provided to mark Tip & Tool Stands with the name of the
associated handpiece.
10. If you have purchased an optional foot pedal, insert the
connector plug into the PEDAL Receptacle on the rear
panel of the power source. Install additional handpieces
and accessories as necessary.
11. Plug the prong end of the power cord into a convenient
three wire grounded AC power outlet. The system is now
ready for operation.
12. Read the "OPERATION" section of this manual
thoroughly before operating the system.
Handpiece Vacuum/Pressure
The SX-80, TP-65 and DTP-80 handpieces require the use of the AUTO SNAP-VAC (vacuum) Port and the TJ-70
handpiece requires the use of the Controllable PRESSURE Port .
There are two preferred methods for connection of the Air Hose. The advantages of each method are discussed
in the paragraph below. Select the method best suited to your particular application.
1. TRADITIONAL METHOD - Best suited for single air handpiece configurations. Configuration allows
the Air Hose to be attached to the handpiece power cable. Any TJ-70 ThermoJet handpiece should be
configured using this method.
2. QUICK CONNECT METHOD - Best suited for configurations which include multiple air handpiece
attachment. A single Air Hose can be easily transferred between handpieces using quick connect
Fittings attached to the rear of each handpiece.
20
Figure 5. Handpiece Connection
Figure 6. Foot Pedal Connection
SET-UP
Advertisement
Table of Contents
