Handpiece Vacuum Pressure - Pace MBT 201 Operation & Maintenance Manual

Set-up
SET-UP
Handpiece Vacuum/Pressure
AIR HOSE CONNECTION
There are two methods of attaching the Air Hose from the PACE power source to the air handpiece.
Select the method which best suits your needs. The Quick Connect Method is best suited for
configurations where multiple air handpieces may be in use. The Traditional Method is best suited for
single air handpiece configurations.
Regardless of connection method, ensure that only one Air Hose is
connected to the VisiFilter assembly ( connected to the AUTO SNAP-VAC
Port) or Controllable PRESSURE Port at one time. Attachment to both
ports simultaneously will cause a deterioration of performance.
QUICK CONNECT METHOD
To set up each air handpiece for the quick connect
operation, perform the following steps.
1. Attach a 1 inch length (2.5cm) of clear pvc Air
Hose (P/N 1325-0003-07) to the metal tube in
the back of each handpiece.
2. To the other end of the 1 inch (2.5cm) clear pvc
Air Hose attach a Female Quick Connect Hose
Mount Fitting (P/N 1259-0086). Secure this
short Air Hose to the handpiece power cable
with one Cable Clip (P/N 1321-0085-01).
CAUTION
Figure 5. Handpiece Quick Connect Hose
18