Table of Contents
Advertisement
SET-UP
Procedures
TRADITIONAL METHOD
1. Connect the 54 inch (137cm) length of Air Hose to the metal
tube in the back of the air handpiece.
2. Insert the ribbed end of a Male Quick Connect Hose Mount
Fitting (P/N 1259-0087) into the free end of the 54 inch (137cm)
Air Hose. Secure the Air Hose to the handpiece power cable
with Cable Clips (P/N 1321-0085-01).
3. Prepare a VisiFilter in the following manner.
a) Connect a 1 inch (2.5cm) length of clear pvc Air Hose to
each side of the VisiFilter; push and turn hose onto
VisiFilter nipple to seat.
b) To the free end of the air hose connected to the FLOW IN
side of the VisiFilter, insert the ribbed end of a Female Quick
Connect Hose Mount Fitting (P/N 1259-0086).
c) Insert the ribbed end of a Male Quick Connect Hose Mount
Fitting (P/N 1259-0087) in the free end of the air hose
connected to the FLOW OUT side of the VisiFilter.
d) Connect VisiFilter Air Hose (with attached Male Quick
Connect Hose Mount Fitting) to the power source AUTO
SNAP-VAC Port.
4. For vacuum, insert Male Quick Connect Hose Mount Fitting connected to long Air Hose into
Female Fitting on 1 inch (2.5cm) Air Hose (connected to VisiFilter). For pressure, insert Male
Quick Connect Hose Mount Fitting directly into the Controllable PRESSURE Port.
When removing any Air Hose, turn and pull. DO NOT attempt to pull Air Hose
directly off. Damage to or breakage of fitting or VisiFilter may occur.
Figure 7. Air Hose To Fitting
Figure 8. VisiFilter Preparation
CAUTION
Fitting
Air Hose
21
Advertisement
Table of Contents
