Table of Contents
Advertisement
Operation
System
POWER UP
1. Ensure that the system is properly prepared for operation. Refer to the "Set-Up" portion of this
manual. The handpieces selected for your application should be connected to the unit. Remember,
PACE recommends connecting any air handpiece (which requires a vacuum hose) to channel number 3
(CH 3). Connect any single vacuum hose to either the AUTO SNAP-VAC Port or Controllable
PRESSUREPort.
2. Turn the POWER Switch ON ("1").
KEY LOCK FEATURE
3. An optional Key Lock feature is available from PACE which
prevents unauthorized alteration of: Stored Tip
Temperatures, Tip Temperature Offset values, the
Automatic Temperature Setback, Automatic Power Down
and recalibration features. Check the rear panel of the
system power source. If the Key Lock feature is present
there will be a CAL/SET Key Lock switch located in the
upper left portion of the panel. Use the key to turn the
switch to the UNLOCK position. If the feature is not
present, there will, instead, be a round plastic filler plug at
that location.
Figure 13. Power On
Figure 14. Key Lock
27
Advertisement
Table of Contents
