Split Display Virtual Channel; Features; Wiring; Setup Procedure - Honeywell SC500 Manual

13.1 Features

13.2 Wiring

13.3 Setup Procedure

The Split Display Virtual Channel allows the display of two track, peak or valley
values from any two channels at the same time. One value is displayed on the left
side of the display, and another value is displayed on the right side.
The display setup used to format each value is inherited from the source channel
of the value.
A Virtual Channel exists in software only; it does not occupy a physical slot inside
of the instrument's chassis. However, a Virtual Channel does require a channel
number.
There is no rear-panel connector for a Virtual Channel.
If you are not familiar with operating the instrument in the SETUP menu mode,
see "SETUP Menu mode" on page 23. A listing of all menu item is given in "Setup
Menu Reference" on page 133.
Step 1: Enter the value to be displayed on the left side with
.
SOURCE
Step 2: Enter the value to be displayed on the right side with
.
RIGHT SOURCE
SC Series Instruction Manual - Model SC500

Split Display Virtual Channel

Chapter 13
and
LEFT CHANNEL LEFT
and
RIGHT CHANNEL
page 117