Honeywell SC500 Manual page 111

If the is 5-Point Known Load Calibration...
CALIBRATION TYPE
• The display will read
DOING 5POINT CAL
(where 00000 and UNIT are previously entered as
). When you have applied this load to the transducer, press [ENTER].
UNITS
• The display will read
WORKING
previously entered as
applied this load to the transducer, press [ENTER].
• The display will read
WORKING
previously entered as
applied this load to the transducer, press [ENTER].
• The display will read
WORKING
previously entered as
applied this load to the transducer, press [ENTER].
• The display will read
WORKING
previously entered as
applied this load to the transducer, press [ENTER].
• The display will now read
will indicate and the instrument will return to the RUN mode. If you use
DONE
the [UP] button and [ENTER] to select
the same loads again but in reverse order. This will allow the instrument to
measure and partially eliminate any hysteresis that may be present in the
transducer. After the loads have been applied again, the display will indicate
and the instrument will return to the RUN mode.
DONE
SC Series Instruction Manual - Model SC500
, and prompt you to
, then
APPLY 00250 UNIT
and
KNOWN POINT 2/5 DISPLAY. UNITS
, then
APPLY 00500 UNIT
and
KNOWN POINT 3/5 DISPLAY. UNITS
, then
APPLY 00750 UNIT
and
KNOWN POINT 4/5 DISPLAY. UNITS
, then
APPLY 01000 UNIT
and
KNOWN POINT 5/5 DISPLAY. UNITS
. If you press [ENTER], the display
RETURN PNTS.=NO
RETURN POINTS=YES
APPLY 00000 UNIT
and
KNOWN POINT 1/5 DISPLAY.
(where 00250 and UNIT are
). When you have
(where 00500 and UNIT are
). When you have
(where 00750 and UNIT are
). When you have
(where 01000 and UNIT are
). When you have
, you may now apply
page 111