Display Setup Sub-Menu; Auxn Function Menu Items - Honeywell SC500 Manual

11.5.2
DISPLAY SETUP
Sub-Menu
Menu Item
DISPLAY. DIGITS
Menu Item
DISPLAY. DECPT
Menu
DISPLAY. COUNT-BY
Item
Menu Item
DISPLAY. UNITS
Menu Item
DISPLAY. AVERAGE
11.5.3
AUXn FUNCTION
Menu Items
page 78 008-0671-00
This menu controls how data values are displayed by the channel and transmitted via
serial communications.
Selects the number of digits displayed by the channel. The choices are:
• " " displays both positive and negative numbers with five full digits
5 DIGIT-BIPOLAR
(±99999).
• " " displays positive numbers with six full digits (999999) and nega-
6 DIGIT-UNIPLOAR
tive numbers with five full digits (-99999).
• " displays positive number with seven full digits (9999999) and
7 DIGIT UNIPOLAR"
negative numbers with six digits (-999999).
Selects the decimal point location on the channel's display and serial communications
output. Use the [UP] and [DOWN] buttons to move the decimal point to the right and
left.
Determines by what value the display increments or decrements. This will make the
display less sensitive to a noisy signal. The choices are:
• " "
00001
• " "
00002
• " "
00005
• " "
00010
• " "
00020
• " "
00050
• " "
00100
• " "
00200
Specifies the four character label that is displayed to the right of the channel's values.
NOTICE
This menu item doesn't change the mathematical scaling of the channel's val-
ues; that can be changed by altering the "
menu items and then performing a re-calibration.
When a character position is flashing press the [UP] or [DOWN] button to change the
character. Press [ENTER] to advance to the next character.
Controls the speed with which the channel's display values will update. Display aver-
aging does not affect the DAC Output or peak/valley detection, which will proceed at
the speed selected by the "
• " " means that the display will update four times each second. The channel's val-
ON
ues will be averaged for 1/4 second, then displayed.
• " " means that the channel's display will update as quickly as possible.
OFF
The and
AUX1 FUNCTION AUX2 FUNCTION
Auxiliary Function pins (labeled as "AUX1" and "AUX2") on the Input Channel connec-
tor are activated. These pins are "activated" when they are connected to the DGND
pin. The choices are:
• " " means that activating the pin does nothing.
DISABLED
• " " means that the tracking, peak and valley values will not be updated.
TRACK HOLD
• " " means that the peak and valley values will not be updated.
HIGH/LOW HOLD
• " " means that the peak and valley values are reset.
HIGH/LOW CLEAR
CALIBRATION DATA
-> " menu item. The choices are:
OPERATION FREQ. RESPONSE
menu items determine what happens when the
-> "
KNOWN POINT X/Y