Diagnostics Sub-Menu - Honeywell SC500 Manual

11.5.8
DIAGNOSTICS
Sub-Menu
Menu Item
DAC FULL SCALE
Menu Item
DAC ZERO SCALE
Menu Item
VERSION INFO
Menu Item
DISPLAY ADC
Menu Item
LINEARIZATION
Menu Item
DISABLE CHANNEL
page 86 008-0671-00
When this menu item is selected, the DAC Output is forced to its full-scale output, then
is displayed. This is useful when calibrating or trimming the readout con-
DAC UPDATED
nected to the DAC Output.
When this menu item is selected, the DAC Output is forced to its zero-scale output,
then is displayed. This is useful when calibrating or trimming the readout
DAC UPDATED
connected to the DAC Output.
This menu item displays the part number and revision level of the firmware used by
this channels microprocessor.
The options for this menu item are:
• " " will allow the [VALUE] button to cycle through "
OFF
value) and " " (valley value). This is the recommended option.
LO
• " " will allow the " " (percentage of the Analog-to-Digital converter's full-scale
ON AD
digitizing capability) display source to be available along with "
" " (peak value) and "
HI
the front panel.
The Analog-to-Digital converter counts are displayed as a percentage from -100.00%
to 100.00%.
This can be used to establish the transducer's electrical null prior to mounting. See
"Electrical Null and Transducer Mounting" on page 87 for this procedure.
The options for this menu item are:
• " " will allow linearization data obtained from a 3-Point or 5-Point Known Dis-
ON
placement Calibration to affect a channel's scaled values. This is the recom-
mended option.
• " " will not allow linearization data to effect the channel's scaled values.
OFF
The options for this menu item are:
• " " will bypass the INITIALIZE and RUN modes of the channel. The track, peak
ON
and valley values of the channel are forced to 0.
• " " will allow normal operation of the channel.
OFF
" (valley value) when the [VALUE] button is pressed on
LO
" (tracking value), " " (peak
TK HI
" (tracking value),
TK