Digital-To-Analog Converter (Dac) Output Configuration; Identifying The Output Type; Channel Menu Items; Output Selection - Honeywell SC500 Manual

11.7 Digital-to-Analog Converter (DAC) Output Configuration

11.7.1 Identifying the
Output Type
11.7.2 Channel Menu
Items

11.7.3 Output Selection

page 88 008-0671-00
An AC/AC-LVDT Input channel is available with one of two types of digital-to-analog
(DAC) outputs: voltage or current. You can determine which type of output a channel
has by one of three ways:
• Consulting the instrument's Customer Information Sheet
• Examining the
SYSTEM MENU
the number of the channel. If the channel's type is
output. If the channel's type is
• Examining the channel's circuit board as shown in the figure below.
The DAC Output can be driven by any channel's track, peak or valley value.
See the "Channel Menu" section earlier in this chapter for a complete listing of SETUP
menu items available on the
Jumpers located on the Main Circuit Board determine what outputs are generated
when the value selected to drive the DAC Output (from the
menu items) equals the
DAC. FULL SCALE
Figure 11-3: Digital-to-Analog Output Jumper Locations
DAC. ZERO SCALE
Output
0-5V 2.5 Volts
±5V 0 Volts
0-10V 5 Volts
±10V 0 Volts
-> ->
CONFIGURATION CHANNEL
AC-AC LVDT V
, it has a current output.
AC-AC LVDT I
sub-menu.
DAC. SETUP
and
DAC. ZERO SCALE
DAC. FULL SCALE
Output
5 Volts
5 Volts
10 Volts
10 Volts
nn menu item where nn is
TYPE
, it has a voltage
and
DAC. CHANNEL DAC. SOURCE
settings.
Jumper Block J36
5/10 B/U
jumper jumper
closed open
closed closed
open open
open closed