Starting The S7999 Display - Honeywell S7999D1048 Manual

S7999D1048 COMBUSTION SYSTEM OPERATOR INTERFACE DISPLAY

STARTING THE S7999 DISPLAY

Home Page
The Home page will appear when the device is properly
powered. Make sure a screen similar to Fig. 17, 18, or 18
appears after the S7999D is completely powered up. Select the
setup button to adjust backlight and sound as desired and for
other setup function. If the screen is dim, check Pin 7 and 8
wiring connection.
The Home page is the main screen that leads to all other
pages and is used to select one of the following actions:
• Commission the ControLinks™ Fuel/Air Ratio Control:
• Touch the Fuel/Air Ratio icon and then the
Commission Button to start commissioning a new
system or modify/review the commission settings of
an existing systems.
NOTE: ControLinks™ Fuel/Air Ratio Control (R7999) can
only be commissioned when it is attached to a
COM port (COM 1 or COM 2) that has been setup
for Fuel/Air Ration control only (Commission).
The Baud rate of this COM port must be set for
4800.
• Monitor a burner system:
• Touch the icon (Burner Control, Fuel/Air Ratio
Control, UDC) corresponding to the part of the
system you wish to monitor. Press the Fuel/Air
Control Configuration button to view more
parameter settings of the Fuel/Air Ratio control.
• Monitor application controller.
• S7999D Setup and Diagnostics.
• Touch the setup button to access the display
settings (General setup, Com Port setup, Screen
Saver, Language selection, Home Page Title, Date/
Time), Display Diagnostics (Com port status,
Screen calibrations, Audio & Video tests, Display
reset) Screen Snapshot (view snapshots, transfer
snapshots to USB) and other tools (Curve Builder,
Boiler Key Varibles, Password setting, Control
Setup, Synchronize).
NOTE: Be sure to touch the Save Button to ensure new
settings become effective.
• The "camera" icon in the upper left corner is for screen
snapshot use. Up to 16 snapshots can be stored in the
display and can be copied to a USB memory stick.
The number of actuators displayed on this page will vary
depending on the number of actuators previously wired to the
ControLinks™ Fuel/Air Ratio Control and configured via the
S7999D configuration tool.
65-0321—01
Fig. 16. Home Page - no connection.
Fig. 17. Home Page - connected.
No title is displayed on this page unless specified in "Title" tab
in the display Setup page. The custom title entered by the user
is displayed on the page when selected by the user.
A burner or boiler icon displays on the page designating which
type of system it represents. The user chooses which type of
system it is in display Setup.
If the screen is blank (Fig. 16) with no device icon or the icons
are greyed out (Fig. 18), then no R7999 and no burner systems
are seen by the S7999D. Check for proper wiring connections
and make necessary corrections.
Fig. 18. Home Page—disconnected.
14