Table of Contents
Advertisement
12.6.2
DISPLAY SETUP
Sub-Menu
Menu Item
DISPLAY. DIGITS
Menu Item
DISPLAY. DECPT
Menu
DISPLAY. COUNT-BY
Item
Menu Item
DISPLAY. UNITS
Menu Item
DISPLAY. AVERAGE
page 104
008-0671-00
This menu controls how data values are displayed by the channel and transmitted via
serial communications.
Selects the number of digits displayed by the channel. The choices are:
•
"
" displays both positive and negative numbers with five full digits
5 DIGIT-BIPOLAR
(±99999).
•
"
" displays positive numbers with six full digits (999999) and nega-
6 DIGIT-UNIPLOAR
tive numbers with five full digits (-99999).
•
"
displays positive number with seven full digits (9999999) and
7 DIGIT UNIPOLAR"
negative numbers with six digits (-999999).
Selects the decimal point location on the channel's display and serial communications
output. Use the [UP] and [DOWN] buttons to move the decimal point to the right and
left.
This menu item may be automatically updated by a transducer's Signature Module.
Determines by what value the display increments or decrements. This will make the
display less sensitive to a noisy signal. The choices are:
•
"
"
00001
•
"
"
00002
•
"
"
00005
•
"
"
00010
•
"
"
00020
•
"
"
00050
•
"
"
00100
•
"
"
00200
Specifies the four character label that is displayed to the right of the channel's values.
NOTICE
This menu item doesn't change the mathematical scaling of the channel's val-
ues; that can be changed by altering the "
menu item and then performing a re-calibration.
This menu item doesn't change the mathematical scaling of the channel's values; that
can be changed by altering the "
then performing a re-calibration.
When a character position is flashing press the [UP] or [DOWN] button to change the
character. Press [ENTER] to advance to the next character.
Controls the speed with which the channel's display values will update. Display aver-
aging does not affect the DAC Output or peak/valley detection, which will proceed at
the speed selected by the "
•
"
" means that the display will update four times each second. The channel's val-
ON
ues will be averaged for 1/4 second, then displayed.
•
"
" means that the channel's display will update as quickly as possible.
OFF
CALIBRATION DATA
->
CALIBRATION DATA
FULL SCALE VALUE
->
" menu item. The choices are:
OPERATION
FREQ. RESPONSE
->
"
FULL SCALE VALUE
" menu item and
Advertisement
Table of Contents
Troubleshooting
