Default Display - Honeywell IAQPoint2 Technical Manual

The contents of some menus vary depending on the configuration of the monitor
and on which password was entered� Those variations are noted in the appropriate
sections�
Menu naming conventions
Menus are navigated by pressing the appropriate buttons� Active buttons are
indicated by yellow borders� These buttons will be identified by placing them in
brackets, for example, if the instruction is "Select [Configure]", press the button
which contains the word "Configure"�

Default display

"R" indicates that
the optional relay
The "Set" button appears when
Easy Temperature Adjust is on.
See the Configure > Display menu.
Temperature units can
be changed from
Celsius to Fahrenheit
on the Configure >
Configure Display >
Temp Units menu.
The temperature section is
displayed when Configure >
Configure Display >
Main Disp. Dataset >
Temperature is checked.
The relative humidity section is
displayed when Configure,
Configure Display, Main Disp. Dataset,
or Relative Humidity is checked.
Figure 21. IAQPoint monitor home screen
In the Default Display, the user will see information about the conditions being
detected by the monitor� A typical display is shown here but the exact combination
of data can be customized extensively� Press [Menu] to advance to the password
entry screen or [Occ] (for "Occupied") to override the monitor's programmed
functions� This will allow the building's current status to be maintained for a period
of between one minute to two hours�
3 The [Occ] function can also be configured to activate a relay or receive fieldbus input from a BACnet network�
The person icon indicates
that the occupied
timer is running.
is energized.
"N" indicates
that network
traffic is present.
This section appears if Configure > Configure Display >
Main Disp. Dataset > Occupied Status is checked.
To open
the password
entry screen.
3
The fault icon indicates that
one or more sensors is inoperative.
The gas setpoint is
adjusted via Configure >
Configure Setpoints >
Set Gas Setpoint.
This section appears if Configure >
Configure Display > Main Disp. Dataset >
Gas Graphic is checked. "VOC" will be
196 mm.
displayed instead of "CO2" on models
with the VOC sensor.
This value is displayed if
Configure > Configure Display >
Main Disp. Dataset > Gas Numeric
is checked.
IAQPoint2
25