Wiring - Honeywell SC500 Manual

10.2 Wiring

Pin
1 (left)
2
3
4
5
6
7
8
9
10
11
12
(right)
page 52 008-0671-00
Connect the transducer to a Strain-Gage Input channel by wiring it to the Input Chan-
nel connector (the top connector on the instrument's rear panel). The Customer Infor-
mation Sheet that shipped with the instrument describes which cards are installed in
each channel. The pin-out for this connector is shown on the following table.
Table 4-7: Strain-Gage Input Channel Pin Connections
Label
+EXC
SHUNT1
SHUNT2
+EXC
+SIG
-SIG
+OUT
-OUT
+MEM
-MEM (-)Signature / Digital Ground
AUX1 Auxiliary Function 1
(connect to pin 10 to activate)
AUX2 Auxiliary Function 2
(connect to pin 10 to activate)
The DAC Output and DAC Return pins are only available with Option 58i and are elec-
trically isolated from all other pins on the instrument.
Reference
Function
(+)Excitation
Shunt Relay
Shunt Relay
(-)Excitation
(+)Signal
(-)Signal
DAC Output
DAC Return
(+)Signature
Availability
Pin
10 standard
3 standard
2 standard
10 standard
10 standard
10 standard
8 Option 58i
- Option 58i
10 standard
- standard
10 standard
10 standard