Install Channel Menu Item - Honeywell SC500 Manual

6.2.4
INSTALL CHANNEL
Menu Item
Virtual Channel Installation
Procedure
page 36 008-0671-00
This menu item will add a Virtual channel as the next highest channel number in the
system.
NOTICE
Installing a channel will cause it to use the "default" or "empty" configuration
information for that channel. All other channels are unaffected.
Any calibration data, SensoCode mathematics programs, display setup,
or other information for that channel will be erased to default values.
Use the following procedure to install a Virtual Channel:
1) Enter the SETUP menu mode, then select "
instrument will then present a menu of card types available for installation.
2) Select the card type of the card you wish to install. After you select the card
type to be installed, you are asked "
"NO" or press the [EXIT] button. If "YES" is selected, "
the installation will commence.
3) If the installation was successful, "
failed, you will see one of the following messages:
" ": There is no more memory available for Virtual channels.
CAN'T INSTALL
" ": There are no unused channels available in the instrument.
SYSTEM IS FULL
After installing a Mathematics Virtual channel, you must re-load the SensoCode pro-
gram into the channel with a computer running the "SensoCom Instrument Utility Soft-
ware". See "Mathematics Virtual Channel" on page 119 for more information.
->
SYSTEM MENU INSTALL CHANNEL
". To cancel this operation, select
ARE YOU SURE?
WORKING...
" will be displayed. If the installation
DONE
". The
" is displayed an