JRC JMR-5406-X Instruction Manual page 444

[SLC1] tab/[SLC2] tab
[Setting a serial port on SLC]
Set a serial port on the SLC that is installed as follows.
Setting Item
CH1 to CH8
CH9/CH10
The sensors that can be selected on SLC are indicated below.
*1
However, the sensors that can be selected actually vary depending on the installation setting.
AUTO, Heading Sensor 1, Heading Sensor 2, Log 1, Log 2, GPS 1, GPS 2, GPS 3, GPS 4, Ship's
Clock, Echo Sounder 1, Echo Sounder 2, AIS, NAVTEX, NAVTEX(Japanese), Anemometer, Water
Temperature Metre, Current Metre, Climate Metre, ROT Indicator, Rudder, RADAR1(TT RX),
RADAR2(TT RX), Alert(to BNWAS), GPS/SAT Buoy, WPT(from Plotter)
Section 14 Adjusting and Setting up Equipment (for Services) 14-18
Description of Setting
1. Select the [SLC1] tab or the [SLC2] tab.
2. Enable the serial port of the channel by selecting the
check box.
3. Select a sensor *1 to be connected to the channel on
the [Sensor] combo box. When not selecting a
sensor, select [ - ].
1. Click on the [SLC1] tab or the [SLC2] tab.
2. Enable the serial port of the channel by selecting the
check box.
3. Select a sensor *1 to be connected to the channel on
the [Sensor] combo box. When not selecting a
sensor, select [ - ].
Setting Value
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.