Setting And Operating Target Tracking; Acquiring Target; Automatic Acquisition (Automatic Acquisition) Mode - JRC JMR-7230-S3 Instruction Manual

6.5

Setting and Operating Target Tracking

The Target Tracking function automatically tracks the acquired targets and records and displays the
course and speed of the targets as vector. Alerts can also be output based on the set collision decision
criteria (CPA and TCPA).
Note
At power off and during preparation for transmission, tracking data records are deleted.

6.5.1 Acquiring target

The methods for acquiring targets include Auto Acquisition (automatic acquisition) mode and ACQ
MANUAL (manual acquisition) mode.
Both modes can also be used concurrently.

6.5.1.1 Automatic acquisition (automatic acquisition) mode

By setting up and enabling the automatic acquisition/activation zone (AZ), targets intruding into the AZ
can automatically be acquired/tracked and also issue a new target warning.
Note
If manual acquisition is made in a state in which the number of targets being tracked has reached
the maximum number of targets, the target with the lowest danger level among the targets that
have been captured thus far automatically is erased successively.
Take the following steps to enable automatic acquisition/activation zone (AZ).
1
Click on the [Menu] button on the left toolbar.
The menu is displayed.
2
Click [Alert] - [New Target Alarm] on the menu.
The "New Target Alarm" dialog is displayed.
Section 6 Target Tracking and AIS
6-18