JRC JMR-5406-X Instruction Manual page 487

Install the transceiver unit.
Install the transceiver unit into the scanner unit.
When installing the transceiver unit, put the unit inside, then slide it into the joint of the wave
guide tube.
Push the transceiver unit wholly so that the unit and the joint of the wave guide tube stick
together.
Fix the unit with bolts with washer.
Close the upper housing.
Before closing the upper housing, check that the packing has no abnormality, such as
deformation or cracks.
Also, remove foreign material and dust if attached.
Close the upper housing while pulling the center of the stay
Stay
If any hexagonal bolt is not tightened enough or is loosened, the waterproof performance may be
deteriorated. Be sure to tighten all bolts with specified torque (120 to 150kgf·cm).
15-37 Section 15 Maintenance & Inspection
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
23
24
24
26
27