Alignment Of Data Sets - Zimmer Biomet Zfx EvolutionNEXT Manual

Zfx™ EvolutionNEXT
Delete
Deletes the areas marked in red
Tailoring for crowns
At least two adjacent teeth on each side must be selected
Tailoring for inlays
Also select the appropriate adjacent tooth
Tailoring for bridges
The completed 3D model may not be smaller than the corresponding squash bite, since the protruding teeth
(to the left and to the right of the squash bite) are needed as orientation points for aligning the opposite jaw.
Undo
The most recent commands can be undone.

4.5.9 Alignment of data sets

As a rule, alignment takes place automatically. The user is only required to align data sets manually in cases where
automatic alignment is not possible, e. g. in an Add-Scan.
Manual alignment can be carried out using the "Align mesh" function in the Post Processing operating mode
(→ Chapter 4.6 "Operating mode – Post Processing").
4.5.9.1 Alignment interaction window
Basic data
Preview
Supplementary data
1 Texture
Activate or deactivate the texture of the 3D data model. It is recommended that the texture be deactivated.
2 Preview
Application preview:
×
Three-point marking
×
Automatic precision alignment "Align"
It is recommended that preview be used as it simplifies the alignment and penetration of the automatic precision
alignment function.
32
Supplementary data
1 2 3 4 5 6