Table of Contents
Advertisement
Zfx™ EvolutionNEXT
4.5 Operating mode – Scan
When the order is registered and stored in Zfx Manager 2.0 or in the configurator, the scan button for the scan software is
enabled and the user can immediately start scanning.
4.5.1 User interface Scan mode
4.5.2 Scan Assistant / Help
The Scan Assistant guides the user through the various steps required for the current order. The individual scanning steps
are shown graphically and explained in the information display.
Information display
Information display – the user can obtain detailed instructions on how
the scanning step is to be carried out by left-clicking on the Info icon.
Website
The Zfx GmbH website (www.zfx-dental.com) will be opened.
Scan
Clicking on the
1
an order. (see illustration below)
2
Clicking the
3D data or overwrites existing scan data.
3
Additional scan data
for a step which has already been scanned can be generated
by clicking the
for all scan variants but only for variants such as single tooth
scan or marker scan, as data may be required retrospectively in
these cases.
24
2
1
3
jaw model
shows the scanning steps necessary for
"Scan"
button starts a new scan and gathers
"Add Scan"
button. This application is not active
1 Scan Assistant / Help
→ see Chapter 4.5.2
4
2 Define scan area
→ see Chapter 4.5.3
3 Tooth selection Chapter
→ see Chapter 4.5.4
4 Brightness setting
→ see Chapter 4.5.5
1
2
3
Advertisement
Table of Contents
