Additional Scan - Add-Scan - Zimmer Biomet Zfx EvolutionNEXT Manual

Table of Contents

Zfx™ EvolutionNEXT

4.5.6.3 Possible problems with the additional scan

If some of the defective areas are not closed in spite of the additional scan, it may be necessary to treat the scan object

with an anti-reflection spray. This is, however, only recommended for strongly reflective (shiny) or partly transparent

(impression materials) surfaces.

CAUTION

Do not spray anti-reflection spray into the scanning chamber. Always spray the scan object outside the scanning

chamber as otherwise there is a risk of the system optics becoming contaminated.

4.5.6.4 Starting an additional scan for already completed models

An additional scan is only possible while in Operating Mode. If it is necessary to gather data for already completed models,

the appropriate scan must be restarted from the required point.

NOTE

Only complete the scanning process after carefully checking whether sufficient scan data have been gathered.

4.5.7 Additional Scan – Add-Scan

A scan order with, for example, three specified scan steps (jaw model / teeth / mush bite)

can be extended by one or more scanning steps using the "Add-Scan" function.

This function is necessary when further information relating to a restoration is required

or the scanned data do not cover the desired area.

4.5.7.1 Start Add-Scan

"Add-Scan"

Click the

Position the scan object in the scanner

NOTE

As the scanning step is not defined in the Dental Manager or via the configurator, no preview is available using the

Scan Assistant. The additional scanning step is also displayed as an Add-Scan image after the scan.

Start Add-Scan by clicking the

Enter the name and setting and confirm by clicking

button

"Scan" 1

button.

"OK" 2

Table of Contents