Connection Of Communication Terminal; Connection Of Base I/O Unit; Connection Of Synchronous Feed Encoder - Mitsubishi Electric MELDAS 60 Series Maintenance Manual

4.2.4 Connection of Communication Terminal

Connect the cable for connecting the communication terminal to the "AUX1" connector on the bottom of
the control unit.

4.2.5 Connection of Base I/O Unit

Connect the "CF10" and "CF11" connectors on the front of the control unit with the base I/O unit.
The installation pitch between the base I/O unit and control unit depends on the length of the
connection cable.

4.2.6 Connection of Synchronous Feed Encoder

Connect the synchronous feed encoder (OSE-1024-3-15-68) to the "ENC2" connector on the front of
the control unit.
There is a connection connector for the base I/O unit and for the control unit.
Refer to the respective system specifications for details on the connection destination and usage
methods.
Downloaded from ManualsNet.com
4.2 FCU6-MU011 Control Unit (MELDAS64 compatible)
The partner side connection destination name is "CR02".
(The connection position differs according to the communication terminal.)
search engine
4. CONTROL UNIT
AUX1
CR02
SH21 cable
(FCUA-R000 cable)
I-23
Ex.FCU6-MU0