Trigger Settings - R&S NRP Series User Manual

®
R&S NRPxxA(N)
Filter Terminal Control
Defines how the measurement results are output, also called termination control. See
also
"Moving"
"Repeating"
Remote command:
[SENSe<Sensor>:]AVERage:TCONtrol
Auto Measurement Time
Available only if "Noise Content" is set under
Sets an upper limit for the settling time of the auto-averaging filter, thus limiting the
length of the filter.
Remote command:
[SENSe<Sensor>:]AVERage:COUNt:AUTO:MTIMe

6.5.3 Trigger settings

Describes the trigger parameters. You can define the conditions that have to be fulfilled
for a measurement to be triggered.
Further information:
●
Chapter 9.5.5, "Configuring the
●
Chapter 9.5, "Controlling the
Access: main dialog of the web user interface > navigation pane > "Trigger"
Trigger
Trigger
Trigger
Dropout......................................................................................................................... 48
Holdoff...........................................................................................................................48
Hysteresis..................................................................................................................... 48
User Manual 1177.6017.02 ─ 08
Chapter 9.5, "Controlling the
Outputs intermediate values to facilitate early detection of changes in
the measured quantity. In the settled state, that means when the
number of measurements specified by the averaging factor has been
performed, a moving average is output.
Specifies that a measurement result is not output until the entire mea-
surement has been completed. This means that the number of mea-
surement cycle repetitions is equal to the set averaging factor. If the
averaging factor is large, the measurement time can be very long.
Source...............................................................................................................48
└ <Source>........................................................................................................ 48
└ <Slope>...........................................................................................................48
Level................................................................................................................. 48
Delay.................................................................................................................48
Browser-based user interface
measurement", on page 67.
"<Mode>"
trigger", on page 74
measurement", on page 67
Settings
on page 43.
47