Heartland VALUE Series Assembly Manual page 35

PARTS REQUIRED:
VF
x2
2 x 6 x 48" (5,1 x 15,2 x 121,9 cm)
WTC
x2
2 x 6 x 49-3/4" (5,1 x 15,2 x 126,4 cm)
BEGIN
Place VF eave trim fl ush along edge of roof panel (Fig. A).
1
Screw through roof panel into VF with 1-1/4" screws spaced approximately 7-1/2" apart, as shown.
Install WTC fl ush to edge of roof panel and fl ush to installed eave trim VF.
2
Screw through roof panel into WTC with 1-1/4" screws spaced approximately 7-1/2" apart.
Secure WTC and VF to gable trim with (2) 3" screws into board ends.
3
(Pre-drill using a 3/32" drill bit.)
**Eave trim may need to be trimmed to fi t**
Repeat installation on opposite side.
Flush
3" (7,6 cm)
Screws
WTC
49-3/4"
(126,4 cm)
FINISH
Your eave trim is now installed.
x8
Fig. A
1-1/4" (3,2 cm)
Screws
7-1/2" (19,1 cm) apart
approximately
48"
(121,9 cm)
EAVE TRIM
3" (7,6 cm)
3/32" (2,4 mm) Drill Bit
VF
33
x48
1-1/4" (3,2 cm)
WTC
VF